Easy Macrame Pottery Making and Most Beautiful Models

For home decoration, sometimes ready-to-buy products are not enough. Not only do we want to have a special decoration product, but we also encounter a lot of high prices or not what we want. Macrame pottery, which we will do with your own ideas, will bring a very different atmosphere to your home. If you like growing flowers at home and you are going to use it as part of your home decoration, it is not enough to make one. You can make macrame flower pots in different places such as living room, kitchen, balcony and terrace. Let's look at the necessary materials without going into construction.

 Materials for Macrame

Macrame rope (In this example, 3 mm cotton macrame rope was used.)
Ferrule. (To be used to hang.)
Scissors
Flower pot

Before we start, let's talk about a few important warnings. First You can enlarge and reduce the dimensions according to the flower pot. The metal ring is used to be both decorative and sturdy. You can also use a sturdy plastic ring if you cannot find the metal ring. Another important issue is that security ropes are as important as the hanging place. After use, make sure to use it in a way that is not accessible to children and does not create a safety problem. If you like macrame work, you will also like our article about macrame curtain. We can start building now. First, we cut 8 pieces of 3-meter-long rope we will use to hang. We cut the strings to the iron ring and adjust them to be equal on both sides.

After the ropes we will make a winding knot to have a beautiful look. For the wrapping node you must make the steps described in the picture.

After throwing the wrapping knot we divide the macrame ropes into groups of four. This is the preparation for the square node, which is important for adding visuality to macrame pot.

For each group of four, we assign a square node according to the method shown in the figure below.

After making a square node, we divide into groups as follows.

For the four groups, we measure the square knot to 5 inches or 13 cm after grouping.

We take two of each of the parts we are measuring and we are throwing square knots again. After doing this square node operation for four groups, we can go to the last stage.

The last thing I will do with the ropes is to knit the remaining parts and collect the lower part and create a tassel.

After throwing the knot, we prepare the flower pot we prepared in the macrame pot.

We put the flower pot we have prepared on the knot section of macrame. After placing the iron ring, we can hang where we want.

Finally you can create a beautiful image by hanging where you want.

Macrame Flowerpot Models

 The following macrame pottery models will be inspired by the technique that is very close to the above method. When hanging the pots, you can use ceiling or walls as well as flower pot stadiums.